Published at Wednesday, 31 October 2018. Bathroom Vanity. By Sarah Fleming.
This is an o-ring connection, but I like to put a little bit of pipe joint compound on the threads and the last part of this faucet to install is the pop-up assembly. It has a linkage right here that you lift, and that makes the stop or go down that holds water in the sink.
We're going to cut the manufacture, provides a template and that's the important dimension, because we need to place this inside and then once we get this dimension right, we cut this for the opening for the sink all right now I want to drill a pilot hole, so I get my jigsaw blade in and it will cut the open, it'll fit, I think so so perfect. So we need to cut into this existing, so we can do our new plumbing of a double sinks coming through the wall. We have a copper pipe that actually has a threaded adapter at the end and that's an inch and a half now this is actually an inch and a half female adapter we're going to thread right onto it, and now we can dry fit the rest of our work. Okay, so now you can see that our drain connection is going to go over to our original lab sink.
Here's the branch that's going to come right back and come right through our cabinet, and now I just need to establish what height I need to drill my hole. All of our holes have been drilled, we've got the drain lines and the two lines for hot and cold. We clean it. We glue it and hold it for five counts, and now we make our Y branch connection to the new sink and I'm going to adapt onto the tailpiece is a trap adapter here and a short piece.
Any content, trademark’s, or other material that might be found on the pacificnorthwestmovies.com website that is not pacificnorthwestmovies.com’s property remains the copyright of its respective owner/s. In no way does pacificnorthwestmovies.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 pacificnorthwestmovies.com. All Rights Reserved.