Published at Friday, October 12th 2018. by Frankie Gross in Bathroom Vanity.
Bathroom vanity pendant light. The one we've selected today has a couple of drawers and one door on the side, but it is important to remember when selecting for yourself, you get something that meets your needs. The tools that we are gonna require are a measuring tape. Wall plugs your hammer, drill, your hole, saw a couple of screws, screwdriver your knife, pencil, cordless drill, skill level and, of course, your protective equipment. So the first step, we're gonna do is measure up where our vanity's actually gonna fit and where we have to make the cuts for our pipes. Now we'll work with a 900 vanity today, so we have 1200 here. S
o that would be plenty of room for a 900 to fit. So the first mark we need to make would be at the half-way mark, which is gonna be 600. Now because we know our vanity is 900, it's gonna be 450 each side from that mark. So, let's measure that up and see how we can find out where it's gonna fit. Place your tape measure on the line find the point of 450 on this side and on this side like so. The next step. Are we wanna find out where we're gonna do our cuts for our holes for our plumbing work to fit through. Measure from one side to the middle of our pipe just here. And we'll also do exactly the same for the second pipes on this side.
So the next set of measurements, we'll need to do, is coming out from the wall to find out how far across and how far from the wall we're actually gonna fit our pipes straight down. So again, just looking from the middle of the pipe and the same on the other side as well. So now that I've got my measurements, I've written them down on a piece of paper, so that when I go to work on my vanity, I know exactly where I have to cut. As you can see, this is the back of the vanity here. They usually come with your backing panels. Today, I've taken them off to make it a bit easier to get access to where we have to do our cuts and measurements.
Going from the very very edge from our measurements that we took inside. Our first measurement is going to be 390. And then from the wall. Our measurements were 60, so we're gonna find 60. And we find the two points where they meet and put a nice big mark to see where we have to cut.. Then we do the same for the other pipes. And there we have our two markings for our hole saws to go. Through. Very important part of this is to make sure that you get your hole, saw bigger than the pipes that we have so that when we slide our vanity over the top, it fits nice and easy.
Any content, trademark’s, or other material that might be found on the pacificnorthwestmovies.com website that is not pacificnorthwestmovies.com’s property remains the copyright of its respective owner/s. In no way does pacificnorthwestmovies.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 pacificnorthwestmovies.com. All Rights Reserved.