Published at Monday, October 08th 2018. by Bobbie Wood in Bathroom Vanity.
We've been remodeling this bathroom and it's really coming together. Now it's time for the new sink and vanity, we splurged a little on ours, but you can find options to fit your budget and style now putting in a new sink and vanity is really easy. But if you're planning on rerouting plumbing, you might want to call a plumber in for that part, and if the space you're working in is tight, take some measurements to make sure your new vanity will fit, and once you have an idea on size, make sure you Look at all the styles and options at Lowe's. Now when we started our project, the bathroom look like this we're doing a total bathroom remodel, which meant taking out everything to the wall, studs, of course, that meant removing the old vanity. Here's how we did it.
We started by turning off the water supply and turning on the faucet to release any pressure lines, then we loosen the slip knot at the top of the p-trap. You may have to remove the entire trap. We disconnected the water lines from the valves. Then we cut the sealant along the back splash with the utility knife you might have to tug on the sink top to get it loose.
We used a chisel and Hammer to separate ours from the base, but do this from the inside if you're going to reuse the vanity once the top was off, we remove the screws from the back of the vanity and pulled it out, so our vanity is out and the walls are finished if you need to repair any of your walls now's the time to do it once you've done that I'm doing stalled start by marking the height of the vanity on the wall at three different locations, then mark the width on the wall.Now you should have a rough outline for the new vanity use, a stud finder to locate and mark the wall studs inside the outlined area.
If your new vanity has a back measure, the distance from the wall marks to the pipes translate these measurements to the new vanity bag and cut the pipe holes with the hole saw move the vanity into place. Lining up the marks check that it's level and make adjustments if needed once the base is level drill, a pilot hole at the nearest stud four holes, not in line with studs, you have to use wall anchors, use a type that's made for your wall surface, tile Plaster or drywall now you can attach the cabinet with screws on the part to the sink, go ahead and assemble the sink while it's out, starting with the faucet and the sink train once done. Add a thin bead of silicone adhesive to the rim of the vanity. Be careful how to get it on the face? The sink top is ready to go on.
Any content, trademark’s, or other material that might be found on the pacificnorthwestmovies.com website that is not pacificnorthwestmovies.com’s property remains the copyright of its respective owner/s. In no way does pacificnorthwestmovies.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 pacificnorthwestmovies.com. All Rights Reserved.