Published at Wednesday, 31 October 2018. Bathroom Vanity. By Jackie Irwin.
The steel dowel should slide into the steel cam. This will allow the wooden dowel to line up to the hole. Next, we put the assembly shelf into place, making sure the steel cams are pointed towards the outside of the cabinet. Now we're gonna tighten all the steel cams by gently turning one-quarter turn with the last eighth of a turn, locking the cam into place.
Now we're gonna repeat this process for the bottom assembly shelf steel cams, in with the arrows pointing out wooden dowels in gently tapped into place next we're gonna attach the sub panel, the back rail and the assembly shelf to the table lay one of the two Gables down on the flat surface and start with the sub panel. The per-drilled holes should line up nicely with the clip next we'll install the back rail.
Bathroom vanity starts by removing the instructions and all the contents of the box. We're gonna begin with the two gables lay the gables on a flat surface, we're gonna begin with the steel dowels screw each one of these into the four points, as shown in the instruction sheet. Do this for all four steel dowels and we're gonna repeat this whole process for the second Gable? Next, we're gonna install the clip for the sub panel.
Any content, trademark’s, or other material that might be found on the pacificnorthwestmovies.com website that is not pacificnorthwestmovies.com’s property remains the copyright of its respective owner/s. In no way does pacificnorthwestmovies.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 pacificnorthwestmovies.com. All Rights Reserved.