Published at Wednesday, 31 October 2018. Bathroom Vanity. By Jackie Irwin.
Now we're gonna repeat this process for the bottom assembly shelf steel cams, in with the arrows pointing out wooden dowels in gently tapped into place next we're gonna attach the sub panel, the back rail and the assembly shelf to the table lay one of the two Gables down on the flat surface and start with the sub panel. The per-drilled holes should line up nicely with the clip next we'll install the back rail.
Bathroom vanity starts by removing the instructions and all the contents of the box. We're gonna begin with the two gables lay the gables on a flat surface, we're gonna begin with the steel dowels screw each one of these into the four points, as shown in the instruction sheet. Do this for all four steel dowels and we're gonna repeat this whole process for the second Gable? Next, we're gonna install the clip for the sub panel.
The larger side of this clip goes against the gable and the screws go through the two front wheels holes so we're gonna install the hinge clips and the shelf rails. It's here you need to determine which side the drawers are gonna, be on the left of the right once you've determined, which side the drawers are gonna, be on we're gonna put the hinge clips on one gable and the drawer slides on the other. There's a slide coming up next.
Any content, trademark’s, or other material that might be found on the pacificnorthwestmovies.com website that is not pacificnorthwestmovies.com’s property remains the copyright of its respective owner/s. In no way does pacificnorthwestmovies.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 pacificnorthwestmovies.com. All Rights Reserved.